Cutting Cement Board

I use the cement board to cover a wood floor before tiling. the last time I used it, I cut with a circular saw (what a waste) of dust everywhere. Is there a better way??

Score a few times with a razor knife, then beat him on the edge of something

Use the saw only to mark the board, not seen in half, then break it.

Take a knife to use the back of the back and score instead of a pencil on board.Then board on which you scored it.and pressure on him to be Braek it.Dont try to be the imagination trying to do everything in piece.So do not be afraid of making several pieces ..

Sorry - a jigsaw would be as a mess. There could be some kind of scoring machine. I say predetermine your cuts and cut off with a wax carbide saw. Wear a mask and goggles.

if its board Backer, u can cut it with a knife, if its hard-rock (concrete) of the wetland after the first board marking the line with a pencil and cut, will reduce dust.

Tip: get a box or floor fan and direct it so as to blow dust off of U!

lic. gen. contractor

Not that I know. hate the things. It works well. I had to use a skilsaw score and then jumping up and down the room until she burst to discard. A real pain in the ass.

a utility knife and an edge of the Strait. Score a few times and break. If the map contains fiberglass mesh, you have to cut the other side after his broken and bent 90 degrees.

skill saw. Out!